April 27, 2018

This site has affiliate links and sponsored content. Affiliate links means if you click on my link and buy something, I will earn a small commission from the advertiser at no additional cost to you. Read my Disclosure Policy.

#DIY Soccer Sleeve Ties!

My daughter has been playing travel soccer for years, so a must is soccer sleeve ties for those hot days.   The only place I have seen them is at tournaments and they are about $3-7 a pair.  So I looked around online at a few patters and decided to attempt some on my own.     Things did not go as planned, but they still turned out!

I ordered ribbon online so it would match the team logo. I also ordered Velcro online, unfortunately I ordered the wrong kind! I was able to still make the project work, so I will give you instructions for two ways to make it!


Correct way to make them!
Supplies:
  • (2) 7 inch lengths of Grosgrain Ribbon (you can use any width of ribbon/design) - check out Etsy for some super cute patterned ribbon. 
  • Velcro (not the adhesive kind) cut to match the ribbon width.
  • Sewing machine 
Instructions: 
  1. Cut two pieces of ribbon to 7 inches in length.  
  2. Next cut your Velcro to match the ribbon width.
  3. Fold the ribbon over 1/4 inch, and  place one side of the Velcro over the raw edge and sew around the Velcro. 
  4. Next flip over the ribbon and repeat.   Fold the ribbon over 1/4 inch to cover raw edge, Sew the  opposite piece of Velcro to the top of the ribbon.
How I made mine!

Supplies:
  • (2) 7 inch lengths of Grosgrain Ribbon (you can use any width of ribbon/design) - check out Etsy for some super cute patterned ribbon. 
  • Velcro - Adhesive kind  cut to match the ribbon width.
  • Beacon Fabric Tac (found at most craft stores, runs about $5 a bottle) 
Instructions: 
  1. Cut two pieces of ribbon to 7 inches in length.  
  2. Next cut your Velcro to match the ribbon width.

  3. Fold the ribbon over 1/4 inch, and glue with the Fabric Tac.  Next add Fabric Tac to the adhesive side of the Velcro and firmly place the Velcro over the freshly glued section.
  4. Next flip over the ribbon and repeat.   Fold the ribbon over 1/4 inch to cover raw edge and glue it down with the Fabric Tac.   Then using the  opposite piece of Velcro add Fabric Tac to the adhesive side and push down on the top of the ribbon.
  5. I then covered with wax paper and placed a heavy book on it to hold it in place
My issue was I ordered Velcro online, thinking it was normal only to discover it was adhesive backed.  You can not use it on fabric and if you attempt to sew it with a machine, it will break your needles and ruin your machine.  The only way to fix my error was buy the correct Velcro or the Fabric Tac.   Since I was making over 20 sets, I opted for the glue verses buying and cutting more Velcro.

0 comments:

Post a Comment